Advanced Wireless Communications MINI PRO Uživatelská příručka stáhnout pdf (Strana 234)

❍ The use of wireless devices in hospitals is restricted to the limits set forth by each hospital.

Antenna Use

● In order to comply with FCC RF exposure limits, low gain integrated antennas should be located at a minimum

distance of 20 cm (8 inches) or more from the body of all persons.

● High-gain, wall-mount, or mast-mount antennas are designed to be professionally installed and should be located at

a minimum distance of 30 cm (12 inches) or more from the body of all persons. Please contact your professional

installer, VAR, or antenna manufacturer for proper installation requirements.

Explosive Device Proximity Warning

Warning: Do not operate a portable transmitter (such as a wireless network device) near unshielded blasting caps or

in an explosive environment unless the device has been modified to be qualified for such use.

Antenna Warnings

Warning: To comply with the FCC and ANSI C95.1 RF exposure limits, it is recommended for the adapter installed in

a desktop or portable computer, that the antenna for this device be installed so as to provide a separation distance of at

least 20 cm (8 inches) from all persons. It is recommended that the user limit exposure time if the antenna is positioned

closer than 20 cm (8 inches).

Warning: Intel(R) PRO/Wireless LAN products are not designed for use with high-gain directional antennas. Use of

such antennas with these products in a manner other than as described in the previous section titled, “Antenna Use” is

illegal.

Use On Aircraft Caution

Caution: Regulations of the FCC and FAA prohibit airborne operation of radio-frequency wireless devices because their

signals could interfere with critical aircraft instruments.

Other Wireless Devices

Safety Notices for Other Devices in the Wireless Network: See the documentation supplied with wireless adapters or

other devices in the wireless network.

Local Restrictions on 802.11a, 802.11b, 802.11g and 802.11n Radio Usage

Caution: Due to the fact that the frequencies used by 802.11a, 802.11b, 802.11g and 802.11n wireless LAN devices

may not yet be harmonized in all countries, 802.11a, 802.11b, 802.11g and 802.11n products are designed for use only in

specific countries, and are not allowed to be operated in countries other than those of designated use. As a user of these

products, you are responsible for ensuring that the products are used only in the countries for which they were intended

and for verifying that they are configured with the correct selection of frequency and channel for the country of use. The

device transmit power control (TPC) interface is part of the Intel(R) PROSet/Wireless WiFi Connection Utility Software.

Operational restrictions for Equivalent Isotropic Radiated Power (EIRP) are provided by the system manufacturer. Any

deviation from the permissible power and frequency settings for the country of use is an infringement of national law and

may be punished as such.

For country-specific information, see the additional compliance information supplied with the product.

Wireless Interoperability

The adapter is designed to be interoperable with other wireless LAN products that are based on direct sequence spread

spectrum (DSSS) radio technology and to comply with the following standards:

● IEEE Std. 802.11b compliant Standard on Wireless LAN

● IEEE Std. 802.11g compliant Standard on Wireless LAN

● IEEE Std. 802.11a compliant Standard on Wireless LAN

1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 284 285

Žádné komentáře

Advanced Wireless Communications MINI PRO Uživatelská příručka Strana 234